3110 Stack Communication with Multiple Blade Server NICs
We have a pair 3110-G chassis switches which where configured in a stack. Blade servers were able to communicate over switch 1
switchports but not switch 2 switchports. What's also starnge is after creating interface vlan on swich with ip address on same network as blade servers nic 2 ports are configured I am not able to get mac address reply on any switch 2 port.
The switches were configured in protected mode prior to stack configuration. Anyone familiar with 3110 stack configuration with ability to communicate with multiple blade server NICs?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...