07-13-2012 06:51 AM - edited 03-07-2019 07:45 AM
I am trying to enable dot1q tunneling on a 3110X port-channel interface. We have 4 switches stacked in our Bladecenter. The configuration guide says that enabling dot1q tunneling on an etherchannel is valid but the cli disagrees. Has anybody experienced this issue before?
Cisco IOS Software, CBS31X0 Software (CBS31X0-UNIVERSAL-M), Version 12.2(55)SE5, RELEASE SOFTWARE (fc1)
switch 1 provision ws-cbs3110x-s-i
switch 2 provision ws-cbs3110x-s-i
switch 3 provision ws-cbs3110x-s-i
switch 4 provision ws-cbs3110x-s-i
vlan 4001
name TUNNEL_VLAN
!
!
interface Port-channel3
switchport access vlan 4001
switchport mode access
end
!
MAD_BC8_3110X(config)#inter port-c 3
MAD_BC8_3110X(config-if)#switchport mode dot1q-tunnel
Command rejected: Po3 doesn't support 802.1q tunneling.
MAD_BC8_3110X(config-if)#
MAD_BC8_3110X#show system mtu
System MTU size is 1500 bytes
System Jumbo MTU size is 9198 bytes
System Alternate MTU size is 1500 bytes
Routing MTU size is 1500 bytes
07-13-2012 07:57 PM
Hold on ...
Are you trying to configure 802.1Q Trunking or Q-in-Q Tunneling?
07-18-2012 07:27 AM
Q-in-Q Tunneling
switchport mode dot1q-tunnel
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: