Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

3500 xl: Config file doesn't contain Gigabit 0/2

I consoled into the switch to setup a link between the switch and another 3500 xl switch through GBIC's, and when I went to access the GigabitEthernet 0/2 it doesn't recognize the port. Also when I show config it is missing from the file. Is there a way to get it back?

3 REPLIES
Hall of Fame Super Gold

Post the the command(s)

Post the the command(s) entered and the error message(s).

Community Member

conf tinterface

conf t

interface gigabitethernet 0/2

                ^

Invalid input detected at '^'

Hall of Fame Super Gold

Post the following output:  1

Post the following output: 

 

1.  sh version; and 

2.  sh post. 

 

I'm suspecting the Loopback controller for Gi0/2 has failed.

29
Views
0
Helpful
3
Replies
CreatePlease to create content