Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3500xl reloading because of Ciscoworks RME

we are having a issue and it appears to be after our upgrade to LMS 2.6. It appears that when we make a change such as clearing port security mac-addresses, RME will log on for the change audit and copy the config. Now what is happening is that it logs on 3-4 times and each time it uses a different VTY line. At some point I see the reload in the TACACS logs. It doesn't reload all the time we make a change, but has happened 4 times already. My only workaround I can think of is to limit the # of vty lines coming in. Anyone else see anything like this?

1 REPLY
Silver

Re: 3500xl reloading because of Ciscoworks RME

In order to resolve this issue you need an outside source like Network Time Protocol (NTP), Simple Network Management Protocol (SNMP) or another time synchronization service to which the switch can synchronize. This way you do not need to manually set the system clock.

124
Views
0
Helpful
1
Replies
CreatePlease to create content