03-27-2008 03:53 PM - edited 03-05-2019 10:01 PM
Hello recently I connected my G0/1 (3524) to my Pri msfc. When I connected it to the Pri msfc theswitch failed over to the Sec msfc then failed back, hsrp went into a state change. Is that normal? I looked into it and it only happened for a split second but I would not think that would happen just by trunking a switch. I had already trunked two other switches to the Pri/Sec msfc's. Can someone please help me out with this? Thanks!
03-27-2008 03:56 PM
I think you will find that when you change an interface to a trunk, or any other mode change, it goes down and then back up. This is probably what triggered the changeovers.
03-27-2008 03:57 PM
I had already setup and connected two other 3524 switches.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: