Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3548 IOS transfer

I have a 3548 that will not boot after a power outage. It continually cycles through the post and reboots. I can break into 'switch:' mode and want to try to reload the IOS on the flash to see if it may be the problem. I don't see the 'xmodem' command available though. Can I copy the IOS back to the swith with TFTP or XMODEM from the switch: prompt?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: 3548 IOS transfer

From the switch: prompt, initialize the flash and load the helper commands. After this you should be able to see the xmodem command

switch:

switch:flash_init

switch:load_helper

After this you can do xmodem

http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml

HTH

Narayan

Please rate all posts

1 REPLY

Re: 3548 IOS transfer

From the switch: prompt, initialize the flash and load the helper commands. After this you should be able to see the xmodem command

switch:

switch:flash_init

switch:load_helper

After this you can do xmodem

http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml

HTH

Narayan

Please rate all posts

368
Views
0
Helpful
1
Replies