So I perform a show mac-address and i see the mac address of all the devices attached and the port they are attached to, is there a way to find out what the ip's of the devices and which port they are attached to?
Go to the device that is the gateway for the subnet and do a show arp | inc [mac address]. You could also put an IP (or DHCP) on an interface on the particular vlan (on the 3550) and do the above command.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.