In our comms rm there is a sulphur smell that comes and goes. We are trying to pin point where it is coming from and all UPS', air con, etc have been checked. The only equipment we have in the comms rm is Cisco 3550 switches - do you know if these contain any type of batteries that might give off a smell?
From my experience as an electronics technician for 6 years, the smell of sulphur usually results from electronic components breaking down (getting fried), power supplies in particular. Batteries can give you that smell, too.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...