I was in the process of copying an IOS image from a server to this switch, after deployment. The power was interrupted during transfer and now the switch will only boot to the switch: prompt. I've made sure the flash_init was run, but I don't see the load_helper anywhere in the available command listing, otherwise I would have xmodem'd a new image over. Pls help!
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...