Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3560 Baud rate

Hi all,

I changed the baud rate for the console to 115200bps to speed up an IOS transfer through xmodem but cannot reset it back to the default 9600.Tried "set BAUD 9600" & "unset BAUD" seperately under switch: prompt but with no luck.Any help is much appreciated.

Thanks,

2 REPLIES
Hall of Fame Super Silver

Re: 3560 Baud rate

Hello,

try to reload it and to access it via telnet then modify the confreg in order to have again 9600 bps

or try to use confreg at rommon prompt.

It will make some questions and one of them is about console speed

see :

http://www.cisco.com/en/US/products/hw/switches/ps663/products_password_recovery09186a00800945f7.shtml

Hope to help

Giuseppe

New Member

Re: 3560 Baud rate

Hi Qiusar,

Many thanks fore the feedback but confreg is not supported on 3560.Found the cause.basically the console baud was change to 115200 which was not changed back to defualts.unset BAUD at switch: defaulted the baud to 9600 but as there was a different setting on the startup, output was not readable.

cheers

4756
Views
1
Helpful
2
Replies