Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3560 private vlan: can one physical port be member of multiple communities

with private vlan is it possible to have one physical port be a member of multiple communities? here is and example:

vlan 100

private-vlan primary

private-vlan association 120,130

!

vlan 120

private-vlan community

!

vlan 130

private-vlan community

!

how do i get fa 0/1 to be member of both 120 and 130 vlans? i would like this to happen:

switchport private-vlan host-association 100 120,130

is this possible?

thanks.

2 REPLIES
Silver

Re: 3560 private vlan: can one physical port be member of multip

As an isolated VLAN-Carries traffic from isolated ports to a promiscuous port. As a community VLAN-Carries traffic between community ports and to promiscuous ports. You can configure multiple community VLANs in a PVLAN. Community VLANs-Ports within a community VLAN can communicate with each other but cannot communicate with ports in other communities at the Layer 2 level. I think you can't configure multiple communities on single VLAN.

http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_20_se/configuration/guide/swpvlan.html

Re: 3560 private vlan: can one physical port be member of multip

George,

It's impossible. You can associate one port per a community.

HTH,

Toshi

269
Views
0
Helpful
2
Replies