Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3560 'srr-queue bandwidth shape' weighting

According to some Cisco 360 R&S lab documentation I'm reading the command 'srr-queue bandwidth shape 4 4 0 0' will result in queue's 1 and 2 getting 25% of the shaped bandwidth each.  I could understand this if the last two 0's were 4 but they're not, so how does the weighting allocation work?

The full syntax is as follows, although I don't think the share command has anything to do with the weighting in the shape command?


srr-queue bandwidth shape 4 4 0 0

srr-queue bandwidth share 1 1 7 3

Any help appreciated...

Everyone's tags (2)
4 REPLIES
New Member

Re: 3560 'srr-queue bandwidth shape' weighting

Hi Richard,

the way the shape command works is that the inverse of the specified weight (i.e. 1/4) multiplied by the interface bandwidth will be what is allocated and guaranteed to the queue. So in this case it could be 1/4 * 100Mbps (assuming an FE interface), which is 25Mbps and 25%.of 100Mbps.

If a weight of 0 is specified for a queue, the queue does not participate in shaping and will share the remaining bandwidth with any other queues that also have been assigned a weight of 0.

In the example configuration you gave, the remaining bandwidth for queues 3 and 4 would be 7/(7+3) * 100Mbps and 3/(7+3)*100Mbps respectively.

HTH

Marcel

Re: 3560 'srr-queue bandwidth shape' weighting

Hi,

Just a minor correction to Marcel's reply, the remaining bandwidth for queues' 3 & 4 would be 7/(7+3) * (100Mbps - 25Mbps - 25 Mbps) and 3/(7+3)*(100Mbps - 25Mbps - 25 Mbps) respectively.

Moath,

New Member

Re: 3560 'srr-queue bandwidth shape' weighting

Hi Moath,

in the case when both shaped queues are full, you're absolutely right. That would be a worst-case scenario for the shared queues. When there is no traffic in the shaped queues however, the shared queues should be able to go up to interface speed.

Sorry if I wasn't clear on that.

Cheers,

Marcel

New Member

Re: 3560 'srr-queue bandwidth shape' weighting

Thanks for your responses - I get it now

4030
Views
8
Helpful
4
Replies