Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3560 switch port POE error - %ILPOWER-3-CONTROLLER_PORT_ERR

Hi All,

need some help here.i have a cisco ip phone 7962G connecting to one of the gi port on 3560G-48 poe switch. the ip phone does not seems to boot up.

switch error>>%ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error, Interface Gi0/30: Power given, but Power Controller does not report Power Good

the 'show inline power' shows enough power remaining to provide for an additional 7962G.

i have found previous threads on it, but do not seems to have any solutions.

thanks in advance

1 REPLY

Re: 3560 switch port POE error - %ILPOWER-3-CONTROLLER_PORT_ERR

Hi

Try this and see if it helps

1. Make sure that the devices are correctly grounded.
2. Check the speed/duplex setting on the remote end of the connection.
3. Perform a shutdown and no shutdown on interface

4. If the error message continues: There are several know bugs related to  this message such as CSCeb24148.

5. Is it the only phone type or same phone types are connected to same switch.

If possible, post the model and IOS version of the device to further analysis.

HTH

Hitesh Vinzoda

Pls rate useful posts

2174
Views
0
Helpful
1
Replies