I have a pre-configured 3560 switch that is not connected to the network and I am trying to console in but it looks for the Radius server and password. How can I disable that password on the console port to get in and make my configuration changes...Thanks
Unfortunately it seems that the pre-configuration of AAA has only RADIUS for authentication with no fall back to the local accounts (have you tried a local configured username and password!), if this is the case you'll have to either connect this switch to the network to be able to contact the RADIUS or do password recovery:
I think u have locked out urself i.e in u r radius config they might have not enabled the next login method should be enable or local username and password.try if u can access it with any local username and password.if u r not able to get access then u need to do the password recovery.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...