Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

3560 switch support with BGP and OSPF

Dear All,

Please tell me which image i need to have for the support of BGP and OSPF. I have now

c3560-ipbase-mz.122-25.SEE2.bin. Even i tried c3560-advipservicesk9-mz.122-35.SE1.bin.

But this image also not supported the bgp and ospf.

switch(config)#router bgp 10

switch(config)#Protocol not in this image

Which image needs to upload for the bgp and ospf support.

Switch is 3560-48-PS-S

swamy

4 REPLIES
Silver

Re: 3560 switch support with BGP and OSPF

Hi,

According to the FAQ http://www.cisco.com/en/US/products/hw/switches/ps5528/products_qanda_item09186a00801f3d71.shtml

The ipservices image itself would support your features. Advanced ip services should do it.

Have you enabled "ip routing" command on your switch before starting your configuration?

Hoogen

New Member

Re: 3560 switch support with BGP and OSPF

Hoogen,

Thanks

i works fine

swamy

Cisco Employee

Re: 3560 switch support with BGP and OSPF

Swamy,

You need an IP services image to support BGP and OSPF. The switch you have is with the Standard image i.e Ip base image. You need an enhanced image i.e Ip services.

http://www.cisco.com/en/US/products/hw/switches/ps5528/products_qanda_item09186a00801f3d71.shtml

HTH,Please rate if it does.

-amit singh

New Member

Do we require a SAL to

Do we require a SAL to utilise advanced routing features?

 

Thanks

Brendan

9823
Views
4
Helpful
4
Replies
CreatePlease to create content