03-14-2007 02:44 AM - edited 03-05-2019 02:54 PM
Dear All,
Please tell me which image i need to have for the support of BGP and OSPF. I have now
c3560-ipbase-mz.122-25.SEE2.bin. Even i tried c3560-advipservicesk9-mz.122-35.SE1.bin.
But this image also not supported the bgp and ospf.
switch(config)#router bgp 10
switch(config)#Protocol not in this image
Which image needs to upload for the bgp and ospf support.
Switch is 3560-48-PS-S
swamy
03-14-2007 03:38 AM
Hi,
According to the FAQ http://www.cisco.com/en/US/products/hw/switches/ps5528/products_qanda_item09186a00801f3d71.shtml
The ipservices image itself would support your features. Advanced ip services should do it.
Have you enabled "ip routing" command on your switch before starting your configuration?
Hoogen
03-19-2007 01:02 AM
Hoogen,
Thanks
i works fine
swamy
03-14-2007 03:39 AM
Swamy,
You need an IP services image to support BGP and OSPF. The switch you have is with the Standard image i.e Ip base image. You need an enhanced image i.e Ip services.
http://www.cisco.com/en/US/products/hw/switches/ps5528/products_qanda_item09186a00801f3d71.shtml
HTH,Please rate if it does.
-amit singh
06-01-2015 10:52 PM
Do we require a SAL to utilise advanced routing features?
Thanks
Brendan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: