Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

3560 traffic ratelimiting (IN&OUT)

Hello,

Can anybody help me to configure rate limitting on my 3560 interfaces? I tried to apply a policy-map to an interface and the switch accepts service-policy input but not accpeting service-policy output. Even the switch accepts input policy, it is not working. I heared that engress policing doest support on 3560 platforms due to ASIC limitations. Is there any way to do this.

Your advise much appriciated..

1 REPLY
Super Bronze

Re: 3560 traffic ratelimiting (IN&OUT)

The configuration guide's QoS section should provide the information you seek. E.g. http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_44_se/configuration/guide/swqos.html

97
Views
0
Helpful
1
Replies
CreatePlease to create content