Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3560 v2 install at remote site

I have a remote site that's just installed a Cataylst 3560 v2 which I need to configure. I'm guessing the default username and password are both cisco; however, web GUI and Configuration Assistant won't let me in - both are asking for realm level_15_access. Is there another username/passwrod? I've tried SSH, too. What's the best way I can set this up remotely?

Everyone's tags (1)
2 REPLIES
VIP Super Bronze

3560 v2 install at remote site

I have never used the GUI before, but if you are trying to Telnet or SSH, you need to configure the vty lines before you can access them.  This is assuming you already have an IP address on the switch and it is reachable.

here is an example of vty lines configs for telnet

line vty 0 4

login local

transport input telnet

line vty 5 15

login local

transport input telnet

username test password test123

username test privi 15

or this could be any other username you have on the device.

If you don't have these config, you would need to send some one to console to it.

HTH

New Member

3560 v2 install at remote site

This switch doesn't come with a console cable and there's not another one there. The siwtch is suppsoed to have Express Setup, which I've used before. It did get a DHCP address from the network and not responding at 10.0.0.1.

156
Views
0
Helpful
2
Replies
CreatePlease login to create content