Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

3560 V2 Upgrade

I am trying to upgrade a 3560 V2 to a newer code. I tried it once and it failed about half way through. So I reloaded and tried it again and now I get this message

"Error: Previous upgrade was unsuccessful or aborted. Clean-up is not done"

How do I clean this up to try and do the upgrade again?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: 3560 V2 Upgrade

The error message " Unable to create temp dir "flash:update" happens because an update to

the temp file is created when a failure is experienced.

The temp file is not delete it and it needs to be delete it with command rmdir

flash:update in order to use the archive upload-sw tftp://location/image.bin.

Please use the following command " rmdir flash:update " and try an update IOS again.

You could also use the “delete /force /recursive flash:update” command to delete the file

completely from the switch.

helpful link:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12220se/3750scg/swiosfs.htm#wp

1112309

1 REPLY

Re: 3560 V2 Upgrade

The error message " Unable to create temp dir "flash:update" happens because an update to

the temp file is created when a failure is experienced.

The temp file is not delete it and it needs to be delete it with command rmdir

flash:update in order to use the archive upload-sw tftp://location/image.bin.

Please use the following command " rmdir flash:update " and try an update IOS again.

You could also use the “delete /force /recursive flash:update” command to delete the file

completely from the switch.

helpful link:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12220se/3750scg/swiosfs.htm#wp

1112309

2484
Views
0
Helpful
1
Replies
CreatePlease to create content