Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3560 with two ISP

all,

I have a small shop. we are thinking of add another internet service here. Our current one is no longer trusted. My question is Can I use a 3560 with IPS image to connect the two ISP. Can i run load balance on the 3560 switch

4 REPLIES
Super Bronze

Re: 3560 with two ISP

It depends. Believe at L3, 3560 supports most "standard" routing features, includes those that support multi-path routing, but there's often more involved when moving from one ISP to multiple ISPs. So, a 3560 may, or may not, be suitable in your instance.

Re: 3560 with two ISP

Obi,

IP services image? Are you connecting 2 routers/ISPs with cisco 3560 switch? The easy way is to add 2 default routes on it. Then you do NAT on the routers.

C3560 can't do NAT. Does it still meet your requirements? If so,you can use it.

HTH,

Toshi

New Member

Re: 3560 with two ISP

The ISPs are Ethernet handoff. My plan was to connect them both to the 3560 switch and create a small network between the switch and my ASA firewall.

Re: 3560 with two ISP

Obi,

Like I mentioned, Cisco 3560 switch can't do NAT. So you can use ASA to do so. ASA can't do PBR. You may think of creating 2 interfaces or subinterfaces on ASA to separate 2 ISPs then do 2 default routes.

HTH,

Toshi

431
Views
0
Helpful
4
Replies