Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

3560-X LAN Base - No Static IP routing available

Hello,

I purchased WS-C3560X-24T-L which comes with LAN Base IOS license set however I cannot configure static routing on it. In data sheets under High-Performance IP Routing section it clearly states that you can confiugure up to 16 static routes with LAN Base option.

Anybody had a similar problem to give me any clues how to configure static routing on 3560-X with Lan Base?

Thanks in advance.

Remi

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

3560-X LAN Base - No Static IP routing available

Hi,

According to the configuration guide:http://www.cisco.com/en/US/docs/switches/lan/catalyst3750x_3560x/software/release/12.2_58_se/configuration/guide/swiprout.html#wp1118518

Starting with Cisco IOS Release 12.2(58)SE, switches running the LAN base image support 16 user-configured static routes on SVIs. Static routing configuration is supported on the LAN base image only with the default SDM template and only on SVI interfaces. No routing protocols are supported.

Hope this helps..!

2 REPLIES
Silver

3560-X LAN Base - No Static IP routing available

Hi,

According to the configuration guide:http://www.cisco.com/en/US/docs/switches/lan/catalyst3750x_3560x/software/release/12.2_58_se/configuration/guide/swiprout.html#wp1118518

Starting with Cisco IOS Release 12.2(58)SE, switches running the LAN base image support 16 user-configured static routes on SVIs. Static routing configuration is supported on the LAN base image only with the default SDM template and only on SVI interfaces. No routing protocols are supported.

Hope this helps..!

New Member

3560-X LAN Base - No Static IP routing available

Hi Leo,

Indeed it helps! I had 12.2(55)SE image and after the upgrade I could configure the static routing.

Thanks a lot for your findings.

Best regards,

Remi

575
Views
0
Helpful
2
Replies