We currently have two 5548UP and two 2232PP switches running on 5.1(3)N2(1a) and the plan is to connect our old 3560G switches to 2232 PP using enhanced Vpc.
I enabled spanning tree bpdufilter on the 2232 PP ports so that we can connect switches to them but VTP is not working on those ports. Is there anything that needs to be done on the HIFs for VTP to work.
Does VTP depends on BPDUs? Does enabling Bpdufilter affects VTP?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...