Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

3560G switches-initial config

Hello,

I am trying to bring up three 3560G switches. I don't think they have the StackWise capability like the 3750s but I was wondering if there is a way to have them all act as one switch and thus configure them as one switch.

Thanks in advance! All replies rated.

2 REPLIES
Super Bronze

Re: 3560G switches-initial config

I think the 3560 series supports switching clustering. If they do, that's likely as close as you can get to managing them as one.

Hall of Fame Super Blue

Re: 3560G switches-initial config

Joseph

Just to confirm, yes they do support clustering :-)

Angel, here is a link for setting up clustering on the 3560 -

http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_46_se/configuration/guide/swclus.html

Jon

146
Views
5
Helpful
2
Replies
CreatePlease to create content