Wondering if anyone can help, I have run into a problem deploying some of the new 3560V2 Switches.
Under normal circumstances we send unconfigured switches to site, have a tech plug them into the network, allow it to DHCP up an IP address and then configure the switch using express setup through the web front end.
Basically the same procedure as is supplied in the "Catalyst 3560 Switch Getting Started Guide.pdf" Problem is we have just found with the 3650V2's there appears to be an undocumented username and password enabled on the web front end.
We have tried all the well known ones, and had no luck, our integrator hasn't been much help either.
Does anyone know what the username and password for this "Undocumented feature" is?
We are pleased to announce availability of Beta software for 16.6.3. 16.6.3 will be the second rebuild on the 16.6 release train targeted towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are looking for early feedback from custome...