05-13-2012 08:07 AM - edited 03-07-2019 06:40 AM
Dears
I am trying to connect tow 3560X using a fiber cable (MM)
I have C3KX-NM-10G in both switches (4 ports module)
I have GLC-SX-MM in both switches (connected to G1/1)
both switches are able to see & recognize the NM as well as the SFP
Fiber Cable is tested
Fiber Patch Cord also tested
both ports configured as a trunks
but also the switches are not able to see each other (even when I removed the trunks configuration from both of them)
CDP neibour is showing nothing
no links & no LED blink in any switch
both switches are running c3560e-universalk9-mz.122-55.SE3 IOS
NOTE: there is no any other configuration in both switches
your fast feed back is highly required & appreciated
Solved! Go to Solution.
05-13-2012 10:27 AM
Hi,
Since it is easier to reverse SC type connectors try reversing one of them from the patch panel and test again.
You maybe connecting RX on one site to a TX on the other side.
HTH
05-13-2012 09:38 AM
Can you try reversing your LC patch cord strand on one side of the cable and try again. This module comes with 2 10Gig SFP+ and 2 regular SFP for 1Gig. Can you make sure that both sides are connected to the proper 1Gig ports?
HTH
05-13-2012 10:22 AM
Dear Raza
Thanks for your prompts response
yes both sides are connected to the 1Gb Ports
for the cable reversing the switches are located in two differnt cabinets
where a fiber cable is terminated in a fiber patch panel (SC Connector) (both Cabinets)
& I am connecting both switches to the FPP using LC-SC fiber patch cord
NOTE: all fiber is very well tested
05-13-2012 10:27 AM
Hi,
Since it is easier to reverse SC type connectors try reversing one of them from the patch panel and test again.
You maybe connecting RX on one site to a TX on the other side.
HTH
05-13-2012 11:33 AM
Thanks Raza
appreciated man
that was the problem
05-13-2012 12:50 PM
Glad to help Ashraf.
Thanks for the rating!
Reza
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide