Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

3560X Lan Base

I haven’t messed with a Lan Base switch yet but they were ordered for a project I’ll be working in the near future.  The design was to use them as the default routes for the VLAN’s.  Would this type of configuration work on a Lan Base switch?  Thanks.

!

vlan 10

                desc Data

                ip address 10.1.10.1 255.255.255.0

!

vlan 20

                desc Student

                ip address 10.1.20.1 255.255.255.0

!

vlan 70

                desc Voice

                ip address 10.1.70.1 255.255.255.0

!

vlan 100

                desc Servers/Printers/Mgmt

                ip address 10.0.0.1 255.255.255.0

!

ip route 0.0.0.0 0.0.0.0 10.0.0.254

!

1 REPLY

3560X Lan Base

Hi,

LAN base does not allow inter vlan routing and only let you add one ip (int vlax) for management purpose. Also, you may need to use the command default-gateway as you may not able to enable ip routing. If you need the above configuration, ipbase is preferred.

hth

MS

462
Views
0
Helpful
1
Replies