Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3640-console-connection

Hi, I can not see anything on my 3640 router with IOS 12.0 and config register value 0x3922.

Please adivse me console settings for windows-hyper terminal.

6 REPLIES
Purple

Re: 3640-console-connection

0x3922

Ignores break

*

Boots into ROM if initial boot fails

*

115200 console baud rate

New Member

Re: 3640-console-connection

I did it, still can not see any display..what about flow clontrol,stop bits and flow control?.

Hall of Fame Super Silver

Re: 3640-console-connection

The console connection usually is set with 8 bits, 1 stop bit (I have also seen it work with 2 stop bits), and no flow control.

HTH

Rick

New Member

Re: 3640-console-connection

It woring with 115200-8-N-1 Combination. Thanks for tips But problems is unable to reset enable secret becuase my config register is 0x 3922, which ignores the BREAK sequence.

How can I reset my enable secret.Thanks in advance.

New Member

Re: 3640-console-connection

Fist make sure u r on the correct port COM.

Second, the setup is : 9600, 8, none,1, off.

HTH

New Member

Re: 3640-console-connection

change the baud rates 1 by 1 n check what is showing in screen

if ASCII characters is shown on 9600 baud rate then check on higher your problem will surely solve

One thing more have u put Console connector in AUX interface or Console interface because some time people forget this things

Hope this may help you

B.Regards

196
Views
0
Helpful
6
Replies
CreatePlease login to create content