Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3640 router upgrade.

Folks,

I was tring to upgrade the IOS of one of my 3640 routers and in the process I was notified of lack of enough memory.I had to accept to erase the flash before the upgrade but before that could finish, I had one of my colleagues stepping on the power cable thereby putting the router off. Now when I connect to the router,it takes me to the rommon> mode i guess because it cannot find the IOS to load.

Could someone please show me how I can get the IOS loaded so I can boot into the router.

2 REPLIES
Hall of Fame Super Blue

Re: 3640 router upgrade.

Hi

If you are really sure you have erased your current image you can use xmodem to copy an IOS onto the router but it's not quick, ie. probably want to set it off before you go home.

Attached is a link to using xmodem for a 3600 router.

http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bfac.shtml#proc_3600

HTH

Jon

Super Bronze

Re: 3640 router upgrade.

If you have an external flash card that you could place in another router, you could preload the IOS on it.

106
Views
0
Helpful
2
Replies
CreatePlease login to create content