Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

3750 disaster recovery

My 3750 switch is not booting and is stuck at the prompt switch:

i tried to initialize the flash and load the IOS via the boot command but it gives an error.

Is there any xmodem procedure which i can do to load another software

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: 3750 disaster recovery

Yes, you can use Xmodem to recover the switch. Please use the link below for recovering 3750 from softwaqre failures:

http://www.cisco.com/en/US/products/hw/switches/ps5023/products_configuration_guide_chapter09186a0080476281.html#wp1099467

HTH,Please rate if it does.

-amit singh

4 REPLIES
Cisco Employee

Re: 3750 disaster recovery

Hi Friend,

Have a look at this link

http://www.cisco.com/warp/public/473/192.html#topic2

HTH

Ankur

*pls rate all helpfull post

Cisco Employee

Re: 3750 disaster recovery

Yes, you can use Xmodem to recover the switch. Please use the link below for recovering 3750 from softwaqre failures:

http://www.cisco.com/en/US/products/hw/switches/ps5023/products_configuration_guide_chapter09186a0080476281.html#wp1099467

HTH,Please rate if it does.

-amit singh

New Member

Re: 3750 disaster recovery

thanks for the link..

Is there anyway to increase the baud rate cos it is taking a long time to load the file with the normal rate

New Member

Re: 3750 disaster recovery

Please try the following steps to disaster recovery.


Do check the connections before proceeding:

flash_init
load_helper
dir flash:
set baud 115200 ---> for faster trasfer of image, do open a new hyper terminal with baud rate set to 115200.
copy xmodem:flash:


More details provided in the following link:
http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml

Hope it helps!

Regards,

podhillo

909
Views
0
Helpful
4
Replies
CreatePlease to create content