Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3750 doesn't support radius?

Hello All,

I am trying to configure radius on 3750 but I don't see the commands. I have no ideas why. Could someone help?


cisco WS-C3750-48TS (PowerPC405) processor (revision M0) with 118784K/12280K bytes of memory.
Processor board ID CAT0938R45U
Last reset from power-on
2 Virtual Ethernet interfaces
48 FastEthernet interfaces
4 Gigabit Ethernet interfaces
The password-recovery mechanism is enabled.

512K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address       : 00:15:63:FB:58:00
Motherboard assembly number     : 73-9680-08
Power supply part number        : 341-0028-02
Motherboard serial number       : CAT093909FN
Power supply serial number      : LIT093400A6
Model revision number           : M0
Motherboard revision number     : B0
Model number                    : WS-C3750-48TS-S
System serial number            : CAT0938R45U
SFP Module assembly part number : 73-7757-03
SFP Module revision Number      : A0
SFP Module serial number        : CAT093903W2
Top Assembly Part Number        : 800-25854-02
Top Assembly Revision Number    : B0
Version ID                      : V05
CLEI Code Number                : CNMV300CRE
Hardware Board Revision Number  : 0x01

Switch Ports Model              SW Version            SW Image                
------ ----- -----              ----------            ----------              
*    1 52    WS-C3750-48TS      12.2(46)SE            C3750-ADVIPSERVICESK9-M


% Unrecognized command
Special54-Cyber(config)#radius ?
% Unrecognized command
regexp  resource  rmon  route-map  router


New Member

Re: 3750 doesn't support radius?

That would surprise me.  But I don't have any 3750s to look.

Do the "aaa group server radius" or "ip radius source-interface"

commands exist?  Maybe they pulled it out of global conf

directives and made it all per-group?

Re: 3750 doesn't support radius?


You might just need to enable radius authentication via aaa, and then try adding the radius-server commands ?

do "aaa authentication login xxxxx group radius"

aaa group server radius xxxx

server *.*.*.*

radius-server host x.x.x.x

radius-server key *****

Try this and let us know


New Member

Re: 3750 doesn't support radius?

thanks all. aaa needs to be enable first.

CreatePlease login to create content