Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

3750 etherswitch module with no IOS

I have a 3845 router with two 3750 etherswitch modules installed.   One of the switch modules has no IOS so it's stuck at the switch: prompt.   Anyone know where I can find any documentation on the commands that are available to me?   For instance,

switch: help boot

Usage for "boot" is:

    boot [-n|-j] [-p] [-c] [-f] [-i] [-m] [-notnd] [-notni] [-post] [-skip_post] [-reserve_mem <1-15>] [-no_esp_keepalive] [<filename>]

Also, can I boot this or download an image from a tftp server?   I've used the set command to set the IP, gateway, tftp server etc... but then what?  There's no tftpdnld command.

Thanks in advance....

3 REPLIES
Hall of Fame Super Gold

3750 etherswitch module with no IOS

Community Member

3750 etherswitch module with no IOS

Thanks.   I've read that but it didn't answer my question about documentation on the commands that are available at the switch:  prompt.  Also, the 3750 Etherswitch has no console port.  How would I xmodem the IOS to the switch using the router console port?

Hall of Fame Super Gold

Re: 3750 etherswitch module with no IOS

219
Views
0
Helpful
3
Replies
CreatePlease to create content