Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3750 identification

Is there any way to run a cli command that will show how the switches are numbered (1,2,3 and so on) from the front display panel.  I want to verify physically the switches in the stack.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: 3750 identification

show switch @ the cli will indicate which is the stack master

from the front panel pressing the mode button until you reach the "stack" setting - all switches will blink the number they are in the stack

from interfce x/1 to x/9

HTH>

Andrew.

3 REPLIES

Re: 3750 identification

show switch @ the cli will indicate which is the stack master

from the front panel pressing the mode button until you reach the "stack" setting - all switches will blink the number they are in the stack

from interfce x/1 to x/9

HTH>

Andrew.

New Member

Re: 3750 identification

Kewl thanks I put these guys in about 4 years ago and have not had to mess with them.

Re: 3750 identification

Sure :o) , I know how that goes - all good.

Andrew.

153
Views
0
Helpful
3
Replies
CreatePlease to create content