Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

3750 monitor session - no L2 from switch displayed

I am doing some 802.1x debugging between a Cisco 3750 switch (12.2(37)SE)and some IP phones and attached PCs. I set up a monitor session from one of the ports (source) to another port (destination) that has a PC running Wireshark. When I run the trace I see the EAP messages (including responses) from the IP phones/PCs but I do not see any of the EAP messages generated by the 3750. I have the monitor source session set for "both". Is there a way to see the EAP messages sent by the 3750?

Thanks

Jim

200
Views
0
Helpful
0
Replies