3750 POE Console shows gibberish no matter what baud rate is used.
Hello all. I have a switch here that has an issue. Its a 3750 24 POE model. The issue is that when you connect via the console it shows gibberish no matter what baud rate is used nor what terminal emulation is used. (Even during POST checks) I have tried SecureCRT, HyperTerminal on 3 different machines, along with 3 different cables and with every baud setting 9600 to 115200. I am leaning towards the idea that the hardware is somehow damaged. Otherwise it exhibits no other issues, turns on, powers up does its checks. I just cannot see anything via console and it has no configuration so I can not use ssh/telnet. So that means I can not use the confreg method or the CLI method to change the baud rate, and as far as my research on cisco.com shows there is no hardware baud reset like in the 3600 series. Any ideas or thoughts? Thanks.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...