Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3750 Route map counters

Hi all,

We're running a simple policy map on a 3750 stack (IOS version 12.2(53)SE2), but the route-map counters do not show any matches:

NYKIRDRCX01#sh route-map

route-map remote-route, permit, sequence 51

  Match clauses:

    ip address (access-lists): remoteACL

  Set clauses:

    ip next-hop 192.168.101.5

  Policy routing matches: 0 packets, 0 bytes

However, I've confirmed via our netflow monitor that the traffic we're trying to send to the appropriate next hop is, indeed, getting there correctly.

I've seen issues in the past with a 3750 not reporting counters correctly, so I'm wondering if there is still a bug in this IOS version. Anyone know?

Everyone's tags (4)
2 REPLIES
Hall of Fame Super Bronze

3750 Route map counters

Those are software counters and PBR is done in hardware. Under that platform, the only way to verify PBR is working is by testing with traffic towards the next-hop.

Regards,

Edison

Bronze

3750 Route map counters

Edison is absolutely correct.

These counters are not incremented due to the fact that PBR was performed in hardware. A true test of traffic forwarding is the only way to tell for sure.

870
Views
5
Helpful
2
Replies
CreatePlease login to create content