Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

3750 show config display problem

I have several 3750-48P running version c3750-ipservicesk9-mz.122-44.SE2 IOS and on some of the switches, when you telnet to them, and do a show config, the screen scrolls through the whole config without pausing. On other switches that are exactly the same, as far as I can tell, they pause after a page of information.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: 3750 show config display problem

To set the number of lines on the current terminal screen for the current session, use the terminal length EXEC command.

terminal length screen-length

24 is the default

Hope that helps

8 REPLIES

Re: 3750 show config display problem

To set the number of lines on the current terminal screen for the current session, use the terminal length EXEC command.

terminal length screen-length

24 is the default

Hope that helps

Re: 3750 show config display problem

bang on target Collin. +5.

-> Sushil

New Member

Re: 3750 show config display problem

Excellent, do this stay in after a reboot?

Re: 3750 show config display problem

Save it and it will (write memory)!

New Member

Re: 3750 show config display problem

Actually that command only works in the current session.

terminal length

To set the number of lines on the current terminal screen for the current session, use the terminal length EXEC command.

terminal length screen-length

Syntax Description

screen-length

Your desired number of lines on the screen. The router uses this value to determine when to pause during multiple-screen output. A value of zero prevents the router from pausing between screens of output. When the output exceeds the screen length, it scrolls past.

Defaults

24 lines

Re: 3750 show config display problem

So if you disconnect and come back in it's back to zero?

Works for me across multiple sessions as long as I save before exiting.

New Member

Re: 3750 show config display problem

The correct way to fix it is under the VTY settings.

line vty 0 4

length 24 (default)

mine was set to 0.

Re: 3750 show config display problem

Ahhh, must override the global setting. Thanks for keeping us updated.

239
Views
5
Helpful
8
Replies