I was trying to enable port channeling on 2 ports on a 3-stack of 3750 switches uplinked to a cat 6509, everytime I added the second port to the port-channel group the switch was putting both ports into error disable mode, on the 6509 both uplinks are part on same channel group.
The ports on the 3750 were in g1/0/49 and g3/0/49. By the way, each port that was going to be added to the channel group was at a different physical 3750, I know the 3750 stack acts a single switch so I saw no problems doing port chaneling on ports located on different physical switches...Would anyone have an idea why this didn't work or had similar experience? Thanks!
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.