Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3750 stack config

I am getting ready to deploy several stacks out to some remote sites. We are running 3750G PoE-24/48PS switches.

1. We've already identified our master switches in each stack. Each switch in the stacks are running the same IOS. However, before I connect this current one I'm working on (three 48s and one 24), I want to know if I set up incorrectly. I flashed the IOS to each box individually after we gave each switch it's own unique name. I will add them to stack later today. However, will we see them as just the one box (master) or will we be able to get to each switch in the stack individually (in case of failure, etc). My question is how will we know if a certain switch in the stack fails, and if so, can we troubleshoot that switch remotely?

1 ACCEPTED SOLUTION

Accepted Solutions
Gold
1 REPLY
Gold
226
Views
0
Helpful
1
Replies