cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
480
Views
19
Helpful
4
Replies

3750 Stack consisting of different model switches

Jason Fraioli
Level 3
Level 3

Is it possible to stack these two switches?

3750G - 24 port

3750 - 48 port

Thanks

4 Replies 4

Amit Singh
Cisco Employee
Cisco Employee

You should be able to do it. Please go through the link below for any cavetas.

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_44_se/configuration/guide/swstack.html#wp1189523

-amit singh

Stephen Berk
Level 1
Level 1

Yes, if the IOS of the stack master is compatible with the hardware of any added slaves. Check out this white paper on StackWise and then search Cisco for the appropriate configuration guide(s).

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps5023/prod_white_paper09186a00801b096a.html

arturo.guzman
Level 1
Level 1

No the models of switches have to be the same.

arturo.guzman
Level 1
Level 1

sorry i make a mistake

http://www.cisco.com/en/US/products/hw/switches/ps5023/products_configuration_example09186a00807811ad.shtml

A Cisco 3750 switch can be stacked with any other model of Cisco 3750 switches. Catalyst 3750 switches that run Cisco IOS® Release 12.2(25)SEB are compatible with Cisco EtherSwitch service modules that run Cisco IOS Release 12.2(25)EZ. Catalyst 3750 switches and Cisco EtherSwitch service modules can be in the same switch stack. Within this switch stack, the Catalyst 3750 switch or the Cisco EtherSwitch service module can be the stack master.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: