Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

3750 Stack consisting of different model switches

Is it possible to stack these two switches?

3750G - 24 port

3750 - 48 port

Thanks

4 REPLIES
Cisco Employee

Re: 3750 Stack consisting of different model switches

You should be able to do it. Please go through the link below for any cavetas.

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_44_se/configuration/guide/swstack.html#wp1189523

-amit singh

New Member

Re: 3750 Stack consisting of different model switches

Yes, if the IOS of the stack master is compatible with the hardware of any added slaves. Check out this white paper on StackWise and then search Cisco for the appropriate configuration guide(s).

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps5023/prod_white_paper09186a00801b096a.html

Re: 3750 Stack consisting of different model switches

No the models of switches have to be the same.

Re: 3750 Stack consisting of different model switches

sorry i make a mistake

http://www.cisco.com/en/US/products/hw/switches/ps5023/products_configuration_example09186a00807811ad.shtml

A Cisco 3750 switch can be stacked with any other model of Cisco 3750 switches. Catalyst 3750 switches that run Cisco IOS® Release 12.2(25)SEB are compatible with Cisco EtherSwitch service modules that run Cisco IOS Release 12.2(25)EZ. Catalyst 3750 switches and Cisco EtherSwitch service modules can be in the same switch stack. Within this switch stack, the Catalyst 3750 switch or the Cisco EtherSwitch service module can be the stack master.

284
Views
19
Helpful
4
Replies
CreatePlease to create content