Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3750 stack switch - showing switch 2 ports also

Hi All  ,

I have 3750 stack switch which was part of stacking in the past.

We want to use it as standalone switch at one of the site .

When I checked the show ip int brief output , I am getting switch 2 interfaces also , which is not stacked with Switch 1.

To remove switch 2 ports from the the configuration , I have erased the startup configuration and rebooted the Switch 1 but no luck..Still getting / seeing  switch 2 ports in the "show ip int bri" and "show run" output.

Is there any way to have only switch 1 ports on the switch 1 as switch 2 is not stacked with switch 1.

After executing erase startup , why switch 2 ports are not going off from switch 1.

Thanks ,
M S K       

Thanks , M S K
2 REPLIES
VIP Purple

Re: 3750 stack switch - showing switch 2 ports also

You have to remove the member from the stack:

no switch X provision

where X is the number of the switch to remove (2 in your case).

-- 
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni


--
Don't stop after you've improved your network! Improve the world by lending money to the working poor: http://www.kiva.org/invitedby/karsteni
VIP Super Bronze

3750 stack switch - showing switch 2 ports also

Hi,

Try this:

Login to the switch and rename it to switch-1 and then reboot it.

HTH

103
Views
0
Helpful
2
Replies
CreatePlease to create content