Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3750 stack

Can I use a 3750G-48TS and a 3750G-12S in the same stack?

2 REPLIES
Hall of Fame Super Silver

Re: 3750 stack

Richard

As far as I know there is no problem in combining different models of 3750 in the stack so long as they are running the same code and using the same template.

HTH

Rick

Cisco Employee

Re: 3750 stack

Hi Richard,

It should work fine just take care of one small configuration.

The Cisco Catalyst 3750 series switches use Switch Database Management (SDM) templates to optimize the system resources for specific features dependent on how the switch is used in the network. There are two versions of the SDM templates: Desktop and Aggregator. The 3750-12S switch alone supports both templates. All other model switches of the 3750 series support only the Desktop version.

When a Cisco Catalyst 3750 switch stack consists of 3750-12S and other models, make sure to use only the Desktop SDM template

This is an output from the show switch command when an SDM mismatch exists:

3750-Stk# show switch

Current

Switch# Role Mac Address Priority State

------------------------------------------------------------

*2 Master 000a.fdfd.0100 5 Ready

4 Member 0003.fd63.9c00 5 SDM Mismatch

To change the SDM template on a 3750-12S to Desktop version, complete these steps:

3750-Stk# conf t

3750-Stk(config)# sdm prefer routing desktop

HTH

Ankur

*Pls rate all helpfull post

199
Views
0
Helpful
2
Replies