Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3750 Switch stack question

Hi,

I have just removed a 3750 from an existing stack and want to use it as the first switch in a new stack.  I've cleared the config and the VLAN Db, but the switch number still appeard as 9.  I tried to renumber the switch using the command

switch current-stack-member-number renumber new-stack-member-number

However after that when I run the sh switch command it shows the following

Switch#  Role   Mac Address     Priority Version  State
----------------------------------------------------------
*1       Master 00xx.xxxx.xxxx     15     0       Ready
9       Member 0000.0000.0000     0      0       Provisioned

(Mac address changed)

Even though the switch is not currently connected to anything else?

What have I done wrong?

Dave

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: 3750 Switch stack question

Hi Dave,

Just to be clear, this is a standalone switch right now and is not connected to any other switch in a new stack?If yes, did you try resetting it using command " reload slot "

You cannot use the switch current-stack-member-number renumber new-stack-member-number global configuration command on a provisioned switch. If you do, the  command is rejected.

If you remove a provisioned switch from the switch  stack, the configuration associated with the removed stack member  remains in the running configuration as provisioned information. To  completely remove the configuration, use the no switch stack-member-number provision global  configuration command.

Please have a look at the below link on managing switch stacks:

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_44_se/configuration/guide/swstack.html#wp1112897

HTH,

-amit singh

3 REPLIES
Cisco Employee

Re: 3750 Switch stack question

Hi Dave,

Just to be clear, this is a standalone switch right now and is not connected to any other switch in a new stack?If yes, did you try resetting it using command " reload slot "

You cannot use the switch current-stack-member-number renumber new-stack-member-number global configuration command on a provisioned switch. If you do, the  command is rejected.

If you remove a provisioned switch from the switch  stack, the configuration associated with the removed stack member  remains in the running configuration as provisioned information. To  completely remove the configuration, use the no switch stack-member-number provision global  configuration command.

Please have a look at the below link on managing switch stacks:

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_44_se/configuration/guide/swstack.html#wp1112897

HTH,

-amit singh

New Member

Re: 3750 Switch stack question

Thanks Amit,

The no switch stack-member-number provision did the trick.

Dave

Cisco Employee

Re: 3750 Switch stack question

You are Welcome. Thanks for rating the post.

Cheers,

-amit singh

1216
Views
5
Helpful
3
Replies