Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

3750 to HP portchannel drops?

Does anyone have a work around for this issue. I've got a 3750 connected to an hp 2810 switch in a port-channel setup.

on cisco side

int range gix/x/x -x

channel-group 1 mode active

on the hp side

trunk 47-48 trk1 LACP

Ive been getting drops on the HP side with no errors on the Cisco 3750.

It appears as though the link is working but still getting drops and these equal retransmisssions?

Does anyone have any ideas or known workarounds?

Thanks,

Pat

11 REPLIES
Cisco Employee

Re: 3750 to HP portchannel errors?

What type of drops are you seeing?  Input queue drops, output queue, frame errors etc?

I don't think this would have much to do with the etherchannel itself, as you are using LACP.  As long as its formed, its really pretty simple.  I don't see many issues with this itself.

Also how many drops are you getting....do they increment at a certain rate?

New Member

Re: 3750 to HP portchannel errors?

I'm getting several hundred thousand drops, slowing incrementing as traffic passes.

These are as Rx Drops on the HP switch. The drops increment about 1 per 5-10 seconds during normal traffic periods.

My next step is to force both side of the trunk to 1gig full.

Any idea's?

Cisco Employee

Re: 3750 to HP portchannel errors?

Hello,

How much traffic we are talking about across this etherchannel?

Regards,

NT

New Member

Re: 3750 to HP portchannel errors?

around 1.3Gigabit per second, this is a two port trunk.

Cisco Employee

Re: 3750 to HP portchannel errors?

Hello,

What is the load balancing method you are using? Is all the traffic going

between same two hosts?

Regards,

NT

New Member

Re: 3750 to HP portchannel errors?

active mode on the cisco

Cisco Employee

Re: 3750 to HP portchannel errors?

Can you paste output of :

show int po <>

show run int po <>

show int <>

show run int <>

(Of the physical ports that belong to the port-channel)

show etherchannel <> detail

Is there any kind of flow control done on Hp switches ?

What happens if you make HP as LACP active and Cisco switch as LACP passive?

Sid Chandrachud

Cisco TAC

Cisco Employee

Re: 3750 to HP portchannel errors?

Hello,

Can you post the output of "show etherchannel load-balance" command here?

Regards,

NT

New Member

Re: 3750 to HP portchannel errors?

Load-Balancing

src-mac

this is the default

I think you have hit the nail on the head as the hp uses src-dst ip pairs for load balancing!

Cisco Employee

Re: 3750 to HP portchannel errors?

Hello,

Can you modify both ends to use both source/destination mac for load

balancing?

Regards,

NT

New Member

Re: 3750 to HP portchannel errors?

I did more research and found that the HP only does sa/da ip load balancing and the cisco had the default setup of src-mac.

I will change the cisco to sa-da-ip load balance method tonight and let you know if that fixed it.

Thanks,

648
Views
0
Helpful
11
Replies
CreatePlease to create content