Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3750 - Unable to paste script into terminal session

I have 100+ 3750's that are running various IOS, some stacked and some not, and all seem to have the same problem.

If I attempt to paste a configuration into the terminal session I get booted after about 10 to 15 lines.  This happens when using SSH and Telnet.  Telnet will go a little further before I'm booted.  After I'm booted it sometimes takes a minute before I can log back into the switch.

Has anyone else had any issues pasting configs into a 3750 via a VTY session?

Thanks,

Mike

2 ACCEPTED SOLUTIONS

Accepted Solutions
Purple

3750 - Unable to paste script into terminal session

  Quick reply is no .  Try a different emulator. 

Hall of Fame Super Gold

3750 - Unable to paste script into terminal session

Never heard of this before.

Like Grant said, try a different telnet/ssh client.

4 REPLIES
Purple

3750 - Unable to paste script into terminal session

  Quick reply is no .  Try a different emulator. 

Hall of Fame Super Gold

3750 - Unable to paste script into terminal session

Never heard of this before.

Like Grant said, try a different telnet/ssh client.

Gold

3750 - Unable to paste script into terminal session

Hi

I have had problems on a serial link that the switch/router (mostly old routers) gets to many characters in a to short timespace when using hyperterminal.

The solution to that have been to setup the spacing between each character with one ms or more.

this have mostly happened on old routers.

When I am using Putty, sometimes when I send at the same time as I get responses from the switch/router the putty client just locks up, i am not sure that if this is due to the serial drivers of my usb dongle or something else.

The problems you are talking about I have not encountered, are the IOS the same version all of them ?

if so just test to change the version of ios.

If they do not have the same IOS or if the problems have spanned multiple versions then I would also test another serial/telnet/ssh client just as Glen and Leo have suggested.

And just a security caution, do not use telnet for access to the switches, use ssh instead.

telnet sends all commands and text in cleartext but ssh encrypts it so it will not get intercepted between you and the switch/router.

Good luck

HTH

New Member

3750 - Unable to paste script into terminal session

Thanks for replies.  The resolution was a combination of things.

1. Outdated terminal software

2. Set switches to SSH v2

Thanks,

Mike

308
Views
0
Helpful
4
Replies
CreatePlease login to create content