Hello,
i have a working Stack of 3750-X
Switch# Role Mac Address Priority Version State
----------------------------------------------------------
*1 Master 4c00.827f.f500 15 1 Ready
2 Member 4c00.8279.9d80 14 1 Ready
3 Member 4c00.8279.9a80 13 1 Read
...
Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 30 WS-C3750X-24 12.2(55)SE5 C3750E-UNIVERSALK9-M
2 30 WS-C3750X-24 12.2(55)SE5 C3750E-UNIVERSALK9-M
3 30 WS-C3750X-24 12.2(55)SE5 C3750E-UNIVERSALK9-M
sw-ced.71#dir
...
6 drwx 512 Mar 1 1993 01:08:19 +01:00 c3750e-universalk9-mz.122-55.SE5
i'm adding a WS-C3750X-48P (different model) but the new switch cannot be stacked
Some hint:
1) Release IOS are identical
2) I tried to manually provision the new stack with stack provision command
3) Priority and switch number are set manually in oreder to have a correct sequencing (switch 4 - priority 11)
4) debug platform are enabled on stack but we nothing is triggered in debug
5) show switch stack-ports summary see ports down and connected
If an erroror or mismatch is present i wish to see it in swhow switch but nothing is displayed ...
When i boot up the new switch ... it makes all post operation and then enter in master election phase ... finish this task without discover the stack ... and boot up in stand alone mode ...
Someone can help me ?
Thank you very much !
