Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3750G configuration stack commands

Using a current 2950, and replacing with a 3750G POE-with an additional 3950G as a back-up (stack) is there a configuration sheet that will give me a step-by-step CLI so I can configure the new switch with my current 2950 configuration?

5 REPLIES
Hall of Fame Super Silver

Re: 3750G configuration stack commands

Hello Leroy,

I would first configure the stack of the two new C3750s.

Actually, the ports will be seen as 1/0/x and as 2/0/y after you have the stack running.

After having done this, the configuration of the single port can be copied to the right port(s).

port 0/x on c2950 becomes 1/0/x and 2/0/x on the c3750 stack if you want to have a backup switch.

if the second C3750 is for backup I wonder if the stack is useful.

Hope to help

Giuseppe

New Member

Re: 3750G configuration stack commands

If I the 3750 config works I will let everyone know the details less headaches for everyone else

New Member

Re: 3750G configuration stack commands

Hi Leroy,

Hi i think it will be better if the other switch is 3750 as well .Here is the link

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_44_se/configuration/guide/swstack.html

New Member

Re: 3750G configuration stack commands

Hey Dave,

Thanks for your help-this may get me rolling in the right direction.

Regards,

Roy

New Member

Re: 3750G configuration stack commands

Thanks

don't forget to rate

HTH

DAk

427
Views
0
Helpful
5
Replies