Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

3750G- Port Rate limiting to 90%

iam planning to limit the gig port usage on 3750 switch to 90%. Apart from "srr-queue bandwidh limi 90" , any other commands needed to be added. The switch do not have QOS or anything enabled at thsi time.

Thank you in advace

MS

3 REPLIES
Super Bronze

Re: 3750G- Port Rate limiting to 90%

If that's all you need to accomplish, should be enough, but do note:

Usage Guidelines

If you configure this command to 80 percent, the port is idle 20 percent of the time. The line rate drops to 80 percent of the connected speed. These values are not exact because the hardware adjusts the line rate in increments of six.

Re: 3750G- Port Rate limiting to 90%

Thank you.. just for clarification.. Don't i need to enable 'AutoQOS" or any mls qos on the switch for the colmmand to work..?

Rgds

MS

Super Bronze

Re: 3750G- Port Rate limiting to 90%

No, don't need Auto-QoS, however you may need to activate QoS with the global "mls qos" command.

116
Views
0
Helpful
3
Replies
CreatePlease login to create content