Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

3750x IP Services EIGRP?

The switch doesn't take the "no auto-summary" command for EIGRP.  Running C3750E-UNIVERSALK9-M IPServices feature on a 3750x-12.  Am hoping to use as a layer 3 switch but it has to fully run EIGRP, do I have the wrong IOS or the wrong switch?

1 REPLY
VIP Super Bronze

If you have IP Services

If you have IP Services license, it means you can run full EIGRP, OSPF, BGP, etc..

As for not being able to apply the "no auto-summary" command, it maybe because in the newer IOS version it is by default disabled.

from the command reference guide:

Command Default

The behavior of this command is enabled by default (the software does not send subprefix routing information across classful network boundaries).

Cisco IOS Release 15.0(1)M, 12.2(33)SRE, 12.2(33)XNE, Cisco IOS XE Release 2.5, Cisco IOS Release 12.2(33)SXI4 and Later Releases

The behavior of this command is disabled by default (the software sends subprefix routing information across classful network boundaries).

link:

http://www.cisco.com/c/en/us/td/docs/ios/iproute_eigrp/command/reference/ire_book/ire_a1.html#wp1062919

HTH

 

62
Views
0
Helpful
1
Replies