Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3750X : use of the cos-output-q map

Hello,

I don't understand under which conditions the cos-output-q map is used.

As an internal DSCP label is added to the packets following classification (for non IP packets, the

cos-dscp map would be used to assign a DSCP label, as documented in the attached diagram from the 3750X Cisco documentation),

all queuing should be done with this internal DSCP label.

So when is the cos-output-q used (the same question applies to the cos-input-q map)?

Thank you!

Arnaud

Everyone's tags (2)
1 REPLY
Cisco Employee

3750X : use of the cos-output-q map

The things is that you want to prefer to trust COS within your switch wich is basically default. That's why you would need input and output cos queue maps. If you start trusitng DSCP then that is prefered over COS.

Nik

363
Views
0
Helpful
1
Replies